Resetting The Ecm Diagnostic Data And The Tip-Over Light

Engine Control Module (ECM) Diagnostics

Code Description

E36

E37

E38

E39

5.10

To reset the ECM diagnostic data, and turn off the tip-over light (a), carry out the

following procedure.

1. Connect the diagnostic tool. See section Connecting the Diagnostic Tool.

2. Enter the diagnostic mode of the ECM. See section Entering the ECM

Diagnostic Mode.

Note: Before proceeding, it is important to realize all stored data will be erased.

3. While in the diagnostic mode,

press and hold both buttons of the

diagnostic tool for approximately 5

seconds and observe the ECM

LED displays.

The ECM LED displays will change

to nine dashes once the ECM has

been reset.

High glow plug relay coil current

High RX power relay coil current

High LED ring output current

Open

wc_gr012205

RT / RTx

wc_tx003818gb_FM10.fm

Resetting The Ecm Diagnostic Data And The Tip-Over Light – Wacker Neuson RT82-SC3 Operator’s Manual [Page 84]