To properly display this page you need a browser with JavaScript support.

UEFI BIOS – EZ Mode

 

The monitor will display the ASUS UEFI BIOS screen as shown below.

 

 

There is a ton of useful information being displayed on this screen.

 

To make it easier to read, the screen is divided into panels.

 

Let’s examine them one at a time.

 

The header shows that you are viewing the

ASUS UEFI BIOS

Utility in EZ Mode.

 

The Date and Time set at the factory are displayed.

 

The Language is set to English

 

F11 opens the EZ Tuning Wizard.

 

 

The panel below the header shows the critical information:

 

The Motherboard model is X99-AII

The BIOS version installed is 0401

 

The CPU detected is an Intel Core i7-6800K processor

Clock Speed = 3400MHz

 

Total installed Memory = 32768 MB

The Memory Frequency of the DDR4 RAM Modules = 2133MHz.

 

 

Right next to it is a graph showing the CPU Temperature.

 

The CPU Temperature has stabilized at 36 degree C.

 

The CPU Core Voltage is 1.087V

 

The Motherboard Temperature is 31 degree C.

 

 

Typically, the CPU Temperature will run 5 to 10 degrees hotter than the Motherboard Temperature at idle.

 

What if your CPU Temperature shows a reading of 45 degree C or higher at idle?

 

This means there is a problem with your CPU Cooler installation. Most likely you have applied too much or too little Thermal Paste. You would need to shut down the system, remove the CPU Cooler, remove the Thermal Paste, reapply the right amount, and put the system back in place.

 

The upper right panel shows how the system is currently tuned.

 

Your system is tuned for

Normal

operation by default.

This is good.

Keep this setting.

 

 

The middle panel shows the Memory Status

 

The Motherboard has detected four Kingston 8GB Memory Modules in these slots:

 

DIMM_A1

DIMM_B1

DIMM_C1

DIMM_D1

 

The Memory Frequency is 2133MHz.

 

 

The Boot Priority Panel on the right shows all your boot devices.

The Motherboard has correctly detected the Samsung SSD 950 PRO 256GB device.

 

When you have multiple boot devices, they will appear stacked in this panel.

You can switch the boot order.

 

 

F8 opens the Boot Menu

 

The bottom panel displays the common shortcuts.

 

To Save and Exit, press F10

 

To go back to the Default Settings, press F5

 

To enter the Advanced Mode, press F7

 

 

At the moment you are in the EZ Mode.

 

F7 acts like a toggle switch between the Advanced Mode and EZ Mode

.